Cyber Commander™ and two CyberSync™ by Paul C. Buff

Description

Cyber Commander™ and two CyberSync™ Transceivers From Paul C. Buff web site OVERVIEW The Cyber Commander™ allows for wireless triggering of flash units. Additional features include:, adjusting the outputs of both the flashbulb and modeling light directly from the camera position, grouping certain lights in a setup together, as well as naming the individual lights in the setup. Last, but certainly not least, the Cyber Commander™ even has a built in light meter! FEATURES Use on the camera hotshoe or handheld when the CyberSync™ trigger transmitter (CST2) is attached to the camera Up to 400' of wireless working range via radio frequency (2.4 GHz band) 16 frequencies to choose from 16 available channels, providing complete control of up to 16 different flash units 8 slots available for grouping of different flash units in a setup Adjusts both flash power and modeling lights in 1/10 f-stop increments Built-in light meter measures individual lights, groups, or all lights together Stores and retrieves over 50 complex lighting setups Compatible with the CyberSync™ Plus Model Receivers (CSR+ or CSRB+) when used with AlienBees™ or White Lightning™ flash units Compatible with the CyberSync™ Transceiver (CSXCV) when used with DigiBees™ or Einstein™ flash units Dimensions 2 in. (width) x 4.75 in. (height - including antenna) x 0.75 in.(depth) LCD Screen Dimensions 1.5 in. (width) x 2 in. (height) System Frequency Range 16 frequencies spaced 2MHz apart (from 2.427GHz to 2.457GHz) System Encoding Secure 256-bit binary encoded packet, with validity verification System Latency 1/4000 typical delay from closing of camera contact to receiver sync output signal Battery Life 6.5 to 8.5 hours under normal use with premium alkaline batteries (uses two AAA alkaline or lithium batteries) Sync Voltage Less than 4 Vdc CyberSync™ Transceiver The CyberSync™ Transceiver is designed for use with DigiBee and Einstein™ flash units. The transceiver fits into the receptacle located on each flash unit. This forms an all-digital interface between the flash unit and the CyberSync™ Trigger Transmitter 2 (CST2), CyberSense remote, the Cyber Commander™, and the discontinued CST. The Transceiver is powered by the flash unit that it is connected to with the frequency and channel selection being made on the back panel of the flash unit. FEATURES All-digital Transceiver Compatible with DigiBee and Einstein™ flash units ONLY Can be used with the CyberSync™ Trigger Transmitter (CST2), or discontinued CST, for wireless firing Full adjustment and wireless firing when used with the Cyber Commander™ NOT compatible with AlienBees™ or White Lightning™ flash units DIMENSIONS / TECHNICAL SPECS CyberSync™ Transceiver Dimensions 1 in. (width) x 2.75 in. (height) x 0.375 in.(depth) System Frequency Range 16 frequencies spaced 2MHz apart (from 2.427GHz to 2.457GHz) System Encoding Secure 256-bit binary encoded packet, with validity verification System Latency 1/4000 typical delay from closing of camera contact to receiver sync output signal Sync Voltage Up to 300 Vdc from a connected flash unit